Over the limit for this fence style
The Overall Length entered for this section is longer than the style allows.
Lengths above the limit can overload the planner. Reset Overall Length and enter a valid measurement.
Configuration overview for your project
Key not working? Click outside the field you’re typing in, or close the open dialog. On a Mac, use Control, not ⌘.
Some measurements are still missing
These sections have no Overall Length, or Calculate was never run on them:
One or more fence sections are incomplete — an Overall Length is missing, or Calculate was never run.
Finish them first for an accurate materials list, or continue with what you have entered so far.
Start this section again from the fencing style
This section will be cleared:
Your other sections are not affected. This cannot be undone.
Remove this section from your quote
This section and everything in it will be removed:
Your remaining sections are renumbered. This cannot be undone.
Panel-to-panel clamps need a minimum gap
The current panel gap is mm, but the minimum gap required for a panel-to-panel clamp is mm.
Would you like to adjust the panel width to allow the required mm gap?
Auto Adjustment recalculates the panel widths and keeps the Overall Length. Manual Adjustment opens Max Panel Spacing so you can set the gap yourself. Cancel keeps the current layout — clamps are not added until the gap is within range.
Measurement Guide
Before you enter your details
Reset the planner and start a new quote
Everything you have entered so far will be removed:
This cannot be undone. A quote you have already saved can be reloaded with its Quote ID.